Home > News > Content
Attention Should Be Paid To The Use Of The Pan Assembly
Aug 02, 2018

Gas confluence is a widely used equipment. It concentrates multiple cylinders together, flows the gas out of a single cylinder, flows through a joint metal hose, and reaches a common confluence tube, where a decompressor is set up to decompress and stabilize the flow of gas. Finally, the gas is pressurization by the set pressure. Stable delivery to the gas terminal. Its appearance has improved work efficiency and ensured clean and safe use of gas in factories.

Manual single side confluence row 1

At present, there are two types of confluence, which are mainly automatic and manual switching. At the same time, as a kind of economical and durable equipment, it is widely used in metal cutting, welding, casting and other processes. The gas, including oxygen, argon, propane and carbon dioxide, is used.

Confluence is still a high pressure product, which is very easy to use. It is very easy to cause danger, such as placing the confluence in the vicinity of the welding operation; putting the flammable and flammable gas cylinder of the oxygen bottle and liquefied gas together, the spacing can not reach the specified standard; the distance between the gas cylinder and the bright fire is too close; and the discharge is missing. Protective early-warning devices and fire-fighting equipment should be used. All these problems may threaten workplace safety.

Therefore, in order to ensure the safety of operation, we must pay attention to matters during the use of the bus bar.

1, inflammable materials such as oil, can not touch cylinders and busbars.  When grease is in contact with some gases, especially oxygen.

And laughing gas, will be ignited;

2. When the bottle valve opens, the action slows down. The heat generated by the compressed gas may ignite some inflammable materials.

3, flexible pipe can not be wound, otherwise easy to cause hose burst;

4. Do not heat up

5. The bus bar should be installed in a dry and ventilated environment, and a sign of fire prohibition and oil prohibition should be set up around it.

6. After the installation of the bus bar, seal test must be carried out before it can be put into operation.

Modern factory automation has become more and more high, all kinds of convenient and efficient equipment are also used, but although the equipment is good, it is necessary to pay attention to the use of safety, especially some dangerous equipment. In accordance with the requirements of use, to ensure safety, in order to maximize the effectiveness of products.


Related News

24 hours at your service:

ivan@cnetec.com

Newsletter

Copyright © Yueqing Etec Electric Co.,Ltd All Rights Reserved.